BAYROL Quicktest Water Test Strips for pH / Chlorine / Bromine / Alkalinity / Algicide, 50 pcs
BAYROL Quicktest water test strips are designed for quick and convenient testing of the most important swimming pool water parameters. A single test strip measures free chlorine or bromine, pH, total alkalinity (TA) and algicide concentration. Regular water testing helps detect changes in water balance early and ensures the correct dosage of water treatment products.
Key Features
- 5-parameter water test strips.
- Measure free chlorine or bromine, pH, total alkalinity (TA) and algicide concentration.
- Fast and easy-to-read results.
- Easy to use.
- Suitable for all types of swimming pools.
- Compatible with all filtration systems.
- No additional reagents or testing equipment required.
- Pack contains 50 test strips.
When to use?
- Before the start of the swimming season.
- For regular water quality monitoring (recommended at least once a week).
- After topping up the pool with fresh water.
- After intensive pool use.
- After heavy rainfall.
- Before adjusting the dosage of water treatment products.
Instructions for use
- Completely immerse the test strip in the pool water.
- Move the strip gently back and forth for approximately 5 seconds.
- Remove the strip without shaking off the water.
- Immediately compare the pH colour with the colour chart on the container.
- After 10 seconds, compare the colours for free chlorine (or bromine), total alkalinity and the remaining parameters with the colour chart.
- To measure the algicide concentration, immerse the strip in the water again for 45 seconds without moving it, then remove it and compare the colour with the chart.
- If necessary, adjust the water balance using the appropriate water treatment products.
Measured Parameters
- Free Chlorine or Bromine.
- pH.
- Total Alkalinity (TA).
- Algicide concentration.
Recommended Values
- Free chlorine: 0.5–1.0 mg/L.
- Bromine: 3–5 mg/L.
- pH: 7.0–7.4.
- Total Alkalinity (TA): 80–120 mg/L.
Quantity
- 50 test strips
Storage
Store in the original tightly closed container in a cool, dry place at temperatures below 30 °C. Protect from moisture and direct sunlight. Close the container immediately after removing a test strip. Do not touch the reagent pads with your fingers.
Warning!
These test strips are intended for water analysis only. They are for single use only and cannot be reused. Always follow the instructions on the product label and use the appropriate water treatment products according to the test results.
