Aquabrome Quicktest, 50 pcs

Water Test Strips for Bromine, pH, Alkalinity & Algicide, 50 pcs

Water Test Strips are designed for quick and convenient testing of the most important swimming pool water parameters when bromine is used as the primary disinfectant. A single test strip measures bromine concentration, pH, total alkalinity (TA) and algicide concentration. Regular water testing helps maintain proper water balance and ensures the effective performance of bromine and algicide treatments.

Key Features

• 4-parameter water test strips.
• Measure bromine concentration, pH, total alkalinity (TA) and algicide concentration.
• Fast and easy-to-read results.
• Easy to use.
• Suitable for swimming pools and spa pools.
• No additional reagents or testing equipment required.
• Single-use test strips.
• Pack contains 50 test strips.

When to use?

• Before the start of the swimming season.
• For regular water quality monitoring (recommended at least once a week).
• After topping up the pool or spa with fresh water.
• After intensive pool or spa use.
• After heavy rainfall.
• Before adjusting the dosage of bromine, algicide or pH balancing products.

Instructions for use

1. Immerse the entire test strip into the pool water.
2. Move the strip gently back and forth for approximately 5 seconds.
3. Remove the strip without shaking off the excess water.
4. Immediately compare the pH colour with the colour chart on the container.
5. After 10 seconds, compare the bromine and total alkalinity colours with the colour chart.
6. To measure the algicide concentration, immerse the strip in the water again for 45 seconds without moving it, then remove it and compare the colour with the chart.
7. If necessary, adjust the water parameters using the appropriate water treatment products.

Measured Parameters

• Bromine.
• pH.
• Total Alkalinity (TA).
• Algicide concentration.

Recommended Values

• Bromine: 3–5 mg/L.
• pH: 7.0–7.4.
• Total Alkalinity (TA): 80–120 mg/L.

Quantity

• 50 test strips

Storage

Store in the original tightly closed container in a cool, dry place at temperatures below 30 °C. Protect from moisture and direct sunlight. Close the container immediately after removing a test strip. Do not touch the reagent pads with your fingers.

Warning!

These test strips are intended for water analysis only. They are for single use only and cannot be reused. Always follow the instructions on the product label and use the appropriate water treatment products according to the test results.